Hmm, now what goes with Earth? A red or a white?
Another nice 3D printer figure from ParagonStar based on the god creatures described in HP Lovecraft's Cthulhu Mythos. This one required
some assembly which was a bit difficult because if you've seen one tentacle, you've seen them all. Seriously though, the +20 piece kit is a very confusing build as far as tentacle placement is concerned. The front mouth was even made up of four parts!
There were alignment holes for each part which the builder would use to help place each piece. Unfortunately, my kit didn't have any 'keys'
for the alignment holes so I had to be very careful in my part selection along with precise alignment which didn't work out all of the time. (I used CA glue as an adhesive.) I had to go back several times to break the part free and try again. Fortunately,
PLA is a pretty tough material so actual physical breakage of any given part was minimal. I have contacted the manufacturer about this issue since I ran into it with another kit and was assured they'd be more attentive in the future.